"format x: /fs:FAT" şeklinde formatlama işlemi çalışmamaktadır. "The volume is too big for FAT16/12" şeklinde uyarı vermektedir.
Farklı yöntem olarak DISKPART dos uygulamasını kullanarak 2 gb alanı set ederek fat ile formatlama yapabiliyoruz; windows command prompt'da diskpart şeklinde yazıyoruz:
Adımlar:
DISKPART> list disk
Disk ### Status Size Free Dyn Gpt
-------- ---------- ------- ------- --- ---
Disk 0 Online 40 GB 0 B
Disk 1 Online 7538 MB 0 B
DISKPART> select disk 1
Disk 1 is now the selected disk.
DISKPART> list part
Partition ### Type Size Offset
------------- ---------------- ------- -------
Partition 1 Primary 500 MB 1024 KB
DISKPART> clean
DiskPart succeeded in cleaning the disk.
DISKPART> create part primary size=500
DiskPart succeeded in creating the specified partition.
DISKPART> active
DiskPart marked the current partition as active.
DISKPART> format fs=fat quick
100 percent completed
DiskPart successfully formatted the volume.
DISKPART> assign
DiskPart successfully assigned the drive letter or mount point.
This creates a 500MB FAT partition as the only one on the disk.
Kaynaklar:list part is only used to make sure I selected the right disk (and the Size shown was from a previous attempt; yours will say something else closer to the full size).http://superuser.com/questions/202160/how-do-i-format-my-8gb-usb-drive-to-fat-fat16-in-windows-7
http://www.instructables.com/id/How-to-format-a-usb-memory-stick-to-FAT/
